Home / Locations / San Ramon, CA / Surge Protection

Surge Protector Installation in San Ramon, CA

Bayshore Electrical Services & Design installs panel-mounted surge protectors across San Ramon and Contra Costa County. It's one of the quickest, most affordable upgrades we do, and it protects equipment that plug-in power strips never touch, like your air conditioner and hardwired appliances.

Call (888) 633-7804 See what's included

Answered 24/7
Price before work starts
Serving all of Contra Costa County

Whole House Surge Protection services in San Ramon

Modern homes are full of circuit boards: in the refrigerator, the furnace, the washer, the garage door opener and every LED bulb. A single surge from the grid can damage them all at once. Whole house surge protection in San Ramon puts a device at your panel that clamps those surges before they reach your circuits.

Surge protector installation

A Type 2 surge protective device wired at the main panel on its own breaker, with short leads for best performance.

Whole house surge protection

Protection for every circuit, including hardwired appliances, HVAC equipment and built-in electronics.

Subpanel and detached building protection

Additional devices for garages, shops, well houses and ADUs fed from the main.

Point-of-use protection

Advice on quality plug-in protectors for computers and home theater as a second layer.

Grounding and bonding checks

Surge devices rely on a good ground, so we test and correct the grounding system as part of the job.

Commercial surge protection

Service-entrance and panel protection for offices, shops and equipment rooms.

Surge protection is worth it if

Lights flicker or dip when large appliances cycle
You've lost electronics after an outage or storm
You have solar, an EV charger or a generator
Your HVAC or appliances have electronic control boards
The panel is being replaced or upgraded anyway

Talk to an electrician in San Ramon

Tell us what you need. We'll give you a straight answer and a time we can be there.

Call (888) 633-7804

Whole House Surge Protection across San Ramon and Contra Costa County

Bay Area households are adding load quickly: EV chargers, heat pump water heaters, induction ranges and home batteries. Older 100-amp panels in San Ramon often can't absorb that without a load calculation and, sometimes, an upgrade. Wind-driven safety shutoffs in the hills also make backup power a common request.

Our whole house surge protection service also covers nearby Diablo, Danville, Dublin, Alamo, Castro Valley and Walnut Creek. ZIP codes served: 94582, 94583.

Whole House Surge Protection cost in San Ramon

Whole house surge protection cost in San Ramon is modest compared with the equipment it protects. The price depends on the device rating and whether the panel has a spare two-pole breaker space. Most installations take about an hour, and it's often added during a panel upgrade for little extra labor.

What happens when you call

Call (888) 633-7804Tell us what you want installed and where. Photos of the panel and the location help us quote faster.
Site check and written priceWe confirm the route, check panel capacity and give you a firm price before starting.
InstallationCable, boxes, devices and equipment are installed neatly, with a permit pulled when the job needs one.
Testing and cleanupEverything is tested and labeled, the work area is cleaned and we walk you through the result.

San Ramon whole house surge protection FAQs

Don't power strips already protect my electronics?

They help with what's plugged into them, but they do nothing for hardwired equipment like air conditioners, ovens and furnaces. A panel-mounted device protects every circuit, and the two work best together.

Where do surges come from?

Utility switching, nearby faults and lightning cause the big ones. Many smaller surges come from inside the building when motors and compressors cycle on and off.

Is surge protection required by code?

Current electrical code calls for a surge protective device when a home's service equipment is installed or replaced. It's also a sensible add-on to an existing panel.

How long does a surge protector last?

Good devices last years, but each surge wears them a little. Most have an indicator light, and we check it during any service visit in San Ramon.

What customers say

After a surge took out our garage door opener and a TV, they installed a whole house protector at the panel. Quick job, clear price, no upsell.
Grace N.Surge protection

After two long outages we had a standby generator put in. They sized it properly instead of pushing the biggest unit, and showed us how the transfer switch works.
Rob H.Standby generator

Twelve recessed lights and two dimmers in the living room, done in a day with no patching needed. The layout advice alone was worth the call.
Tom and Linda W.Recessed lighting

More electrical services in San Ramon

Whole House Surge Protection near San Ramon

Need whole house surge protection in San Ramon?

One call, a clear price and a time that works for you.

Call (888) 633-7804