Home / Locations / San Anselmo, CA / Panel Upgrades
Electrical Panel Upgrade and Replacement in San Anselmo, CA
Bayshore Electrical Services & Design replaces fuse boxes, obsolete breaker panels and undersized services across San Anselmo, Fairfax and Ross. We handle the load calculation, the permit, coordination with the utility and the final inspection, so you deal with one company from start to finish.
Call (888) 633-7804See what's included
- Answered 24/7
- Price before work starts
- Serving all of Marin County
Electrical Panel Upgrade services in San Anselmo
Your electrical panel sets the limit on everything else in the building. If yours is full, outdated or only rated for 100 amps, adding an EV charger, air conditioning or an induction range can push it past what it was built for. An electrical panel upgrade in San Anselmo gives you the capacity and the breaker protection modern loads need.
200 amp panel upgrade
The standard for modern homes, with room for EV charging, heat pumps, solar and future circuits.
100 amp to 200 amp upgrade
New meter base, service entrance conductors, grounding and main panel sized for double the capacity.
Breaker box replacement
Outdated panel brands and worn bus bars replaced with a current, fully labeled load center.
Fuse box replacement
Screw-in fuse panels converted to breakers, with circuits separated and grounded as the wiring allows.
Sub panel installation
Added capacity for garages, ADUs, workshops, additions and pool equipment without replacing the main.
Main panel and service upgrade
Meter, mast or underground service, main breaker and grounding brought up to current code together.
Signs your panel needs attention
- Plans for an EV charger, solar, a spa or central air
- Breakers that trip often or feel warm
- A panel with no open spaces, or doubled-up wires on one breaker
- Fuses instead of breakers, or a 60 or 100 amp main
- Rust, scorch marks or a crackling sound at the panel
Talk to an electrician in San Anselmo
Tell us what you need. We'll give you a straight answer and a time we can be there.
Call (888) 633-7804Electrical Panel Upgrade across San Anselmo and Marin County
Bay Area households are adding load quickly: EV chargers, heat pump water heaters, induction ranges and home batteries. Older 100-amp panels in San Anselmo often can't absorb that without a load calculation and, sometimes, an upgrade. Wind-driven safety shutoffs in the hills also make backup power a common request.
Our electrical panel upgrade service also covers nearby Fairfax, Ross, Kentfield, Greenbrae, San Rafael and Larkspur. ZIP codes served: 94960, 94979.
What affects electrical panel upgrade pricing in San Anselmo
Electrical panel upgrade cost in San Anselmo depends on the amperage, whether the service is overhead or underground, where the meter sits, and what the utility and building department require. A like-for-like panel swap is at the low end; relocating the service or upgrading 100 amp to 200 amp with new grounding costs more. We inspect the existing setup and give you a written, itemized price.
How a visit works
- Call (888) 633-7804 for a site visitWe look at the existing system, listen to what you need and take measurements.
- Load calculation and written quoteYou get an itemized scope and price, with options where there is more than one good way to do it.
- Permits and schedulingWe file the permit, coordinate with the utility or other trades and set dates that work for you.
- Installation and inspectionThe work is completed, tested, inspected where required and explained to you before we close out.
San Anselmo electrical panel upgrade FAQs
How long will my power be off?
For most panel upgrades in San Anselmo the power is off for one working day, typically four to eight hours. We schedule the utility disconnect and reconnect so the outage is as short as possible.
Do I need 200 amps?
If you plan to add an EV charger, electric heat pump, induction range or solar, usually yes. We run a load calculation on your property so the decision is based on numbers, not a sales pitch.
Is a permit required for a panel upgrade in San Anselmo?
Yes. Panel and service upgrades require a permit and inspection, and the utility has to approve the reconnection. We handle all of it.
My panel is an older brand people warn about. Should I replace it?
Some older panel designs have breakers that can fail to trip. If yours is one of them, or shows heat damage, replacement is the safe choice. We'll open it and show you what we find.
In customers' words
After a surge took out our garage door opener and a TV, they installed a whole house protector at the panel. Quick job, clear price, no upsell.
Our old 100 amp panel tripped every time the AC and dryer ran together. Bayshore quoted the 200 amp upgrade on the spot, handled the permit and had us back on by late afternoon.
After two long outages we had a standby generator put in. They sized it properly instead of pushing the biggest unit, and showed us how the transfer switch works.
More electrical services in San Anselmo
- EV Charger Installation in San Anselmo
- Whole House Rewiring in San Anselmo
- Solar Electrician and Battery Backup in San Anselmo
- Whole House Surge Protection in San Anselmo
- All electrical services in San Anselmo
Electrical Panel Upgrade near San Anselmo
Need electrical panel upgrade in San Anselmo?
One call, a clear price and a time that works for you.